Bore Water & Timber Stain Remover
SPiTSeR is excellent for cleaning or removing spear-pump or bore water stains. Green vanadium stains that can occur on light/cream bricks & terracotta if cleaned with hydrochloric acid. Iron stains from radiator spills, or iron stone stains in exposed aggregate or scratch coats. As well as hardwood & tannin stains.
Stains disappear before your eyes!
Be aware that SPiTSeR can bleach some naturally occurring colours, so always pre-test prior to use.
Do not mix with other bleaches or chemicals.
DIRECTIONS FOR USE :
Use SPiTSeR to remove hardwood, spear pump, vanadium (green) or iron stains by applying “neat” with a brush or sponge, allow to work 30-60 minutes, then wash off with water.
As SPiTSeR has a bleaching effect, special care should be taken to avoid a patchy result, if only spot areas are to be treated.
Use on dark brickwork is not recommended unless pre-tested in an unobtrusive place and approved. Repeat application as required.
SAFETY DIRECTIONS: Keep locked up and out of reach of children. Avoid contact with skin & eyes. Avoid breathing spray mist. Do NOT mix with other chemicals.
Special Note: SPiTSeR can react spontaneously with sodium hypochlorite (liquid pool chlorine) releasing chlorine gas.
FIRST AID: If poisoning occurs, contact a doctor or Poisons Information Centre Phone Australia 131126 or New Zealand 03 4747000. If swallowed, do NOT induce vomiting. Give glass of water. If skin contact occurs, remove contaminated clothing and wash skin thoroughly with plenty of soap and water. If irritation persists consult a doctor. If in eyes, hold eyes open, flood with water for at least 15 minutes and see a doctor.
